Trinic H-12 Sealer B-Side Replacement

Availability: In Stock
Product Code: SEA16245_.75-QT

We now offer the Trinic H-12 Sealer B-Side Replacement!

Don’t let an unplanned "oops!" ruin your project or set you behind schedule. At Silica Systems, Inc. we like to save your time and funds in any way we can while still giving you top-of-the-line products. That’s why we now offer this Trinic H-12 Sealer B-Side as a single replacement bottle. Don’t waste money buying the whole kit again when you only need one part. In case of an accidental spill or cross-contamination, or leaving an unsealed bottle opened to dry up, this B-Side replacement is ready to go.

NOTE: You will be single ordering Side-B replacement of the Trinic H-12 Water Based Sealer kit ONLY. Both Side-A and Side-B are required for this sealer kit to work. If you have any questions about ordering the complete sealer kit or how to use it please give our customer service team a call.

NOW AVAILABLE:
  • Easy to apply.
  • Excellent stain, acid, and scratch resistance.
  • Excellent field repair-ability.
  • No chance of catastrophic failure.
  • Clean mixing container.
  • Two syringes for measuring small amounts (to avoid cross-contamination).
  • Clean potable water.
  • High-density foam roller.
  • Combine 2 parts A to 1 part B mix for 1 minute minimum making sure all of the catalyst is thoroughly homogenized within the mixture.
  • First Coat – Add 7 parts water to 1 part sealer.
  • Second Coat – Mix 4 parts water to 1 sealer.
  • Two coats may be adequate for low use areas such as fireplace surrounds.
  • Third Coat (Option 1) – 2 parts water to 1 part sealer.
  • Third Coat (Option 2) – 3 parts water to 1 part.
  • Three coats may be adequate for vanities, a fourth is recommended for high abuse areas such as kitchen countertops.
  • Fourth and final Coat – 2 parts water to 1 part sealer.
  • Flood the surface with diluted H12.
  • Roll with a high-density foam roller.
  • Keep wet for up to 5 minutes or until the concrete stops absorbing sealer.
  • Keep rolling until all foam is gone and roller marks disappear, Ring out foam roller to remove any access material. The thinner the coat the better the scratch resistance.
  • Remember – “Thin to Win.”
  • Once there are no longer roller lines or foam left on surface let sit until the coat is dry to the touch. When you can rub it with your finger and not leave a mark, its ready for the next coat. This generally takes about an hour at 75 degrees, about 2 to 3 hours at 60 degrees.
  • You can use 600 grit sandpaper to remove dust particles from the sealer after it has cured a couple of days, if you attempt to sand the sealer to early in the cure cycle you may end up removing it.
  • The sealer will have excellent blush resistance in three days.
  • The sealer requires seven days to have excellent scratch, acid, and stain protection.
  • The sealer will continue to build hardness out to 14 days.
  • Small scratches can be spot repaired by filling the scratch with sealer and wiping off excess.
  • The sealer can be re-coated by sanding the tops with 200 to 400 grit sandpaper and sealing with an additional coat of sealer.
  • Trinic H-12 Sealer Part I
  • Trinic H-12 Sealer Part II
  • Trinic H 12 Tips and Techniques
Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page

#title#

#price#
×